each, the 16K requires an bit data word address for random word addressing. WP Pin. Status. Part of the Array Protected. 24C01A. 24C 24C 24C08A. 24C04 EEPROM are available at Mouser Electronics. Mouser offers For: 24C Obsolete. Microchip Technology / Atmel, EEPROM 7 MILS V – 10MS V. Read about ’24C04 Interfacing issue’ on elementcom. Hey there,I am trying to interface the AT24C04 4K EEPROM with Atmega
|Published (Last):||27 May 2018|
|PDF File Size:||19.70 Mb|
|ePub File Size:||12.74 Mb|
|Price:||Free* [*Free Regsitration Required]|
Atmel Corporation makes nowarranty which is detailed in Atmel ‘s Atmwl and Conditions located on the Company’s web site. A2 are used for creating the address.
Previous 1 2 Amtel connects the SOT package pins to the same signal position of the 8 pin DIPmechanical and electrical connections are supported by this adapter. Post as a guest Name. Then the address byte that you use to write to the third chip would be 0xA4 atme the address byte for reading the second chip would be 0xA5. However, it doesn’t matter what I set these pins to. Home Questions Tags Users Unanswered.
In figure 4 they refer to the address as an 8-bit quantity:. MO footprint tai 24c02 atmel 24c02 atmel 24c04 tai 24c04 at24c01atsi pin configurations attmel 24c04 1 24c04 Atmel atmel 24c16 Text: TurboJ The chip says the following: Is there something else I need to do?
Full 2K Array 24C04 1. If you just have one 24C02 then you would connect all three of those pins to GND as b. In figure 4 they refer to the address as an 8-bit quantity: No license, express or implied, by estoppel or otherwise, to any. Atmel Corporation makes no warranty for the. Please refer to AT24C08A.
I will try in about an hour. Atmel Corporation makes no warranty for the use. RoomJapan Atmel Japan K.
Then the address byte that you use to write to the second chip would be 0xA2 and the address byte for reading the second chip would be 0xA3. No abstract text available Text: MaNyYaCk 6 Can you give more information? Sign up or log in Sign atmfl using Google. Are you being confused by the common mistake that many people make where they treat the address of an I 2 C wrongly? On top of that I have never been sure that it is even possible atmek dynamically change the strapped value on armel A0, A1 and A2 pins of a 24C02 after it has powered up.
If a total of eight 24C02’s are used in the design then each of the devices will have these three pins hard strapped in a different combination from the set of b, b, b, b, b, b, b and b. You do not write the addresses; you hardwire them. In Arduino, the function that does this is digitalWrite. Email Required, but never shown.
Atmel Corporation makes no warranty for the usedetailed in Atmel ‘s Terms and Conditions located on the Company’s web site. The information in this document is provided in connection with 2c04 products. Normally there is no writing to the 24C02 pins.
Maybe the issue is setting the address after power on. The Company assumes no. Atmel Corporation makes no warranty for atmrl use of its products, other than those expressly contained in.